The issue is now resolved.
- Replaced boot ssd for a new one.
- Installed Truenas on said ssd.
- Imported config/db.
- Unlocked encrypted datasets on data drives.
Really straightforward with Truenas. Thanks to those who took the time to reply 👍
The issue is now resolved.
Really straightforward with Truenas. Thanks to those who took the time to reply 👍
Well, I did mention it was a SSD in the post.
As for backups…
The disks containing the important stuff are higher spec SSD’s.
The data is backed up on 3 different drives - one offsite. So not really worried about dataloss at this point. And I have a fairly recent backup of the Truenas config/db.
The choice to not backup the boot drive, was made to save some money.
Just trying to figure out if a reinstall of Truenas on a new drive is the only option left. 🤷♂️
Output of journalctl is almost same as dmesg:
dec 04 05:22:58 mx kernel: usb 2-1: new SuperSpeed USB device number 17 using xhci_hcd
dec 04 05:22:58 mx kernel: usb 2-1: New USB device found, idVendor=2109, idProduct=0711, bcdDevice= 1.44
dec 04 05:22:58 mx kernel: usb 2-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
dec 04 05:22:58 mx kernel: usb 2-1: Product: VLI Product String
dec 04 05:22:58 mx kernel: usb 2-1: Manufacturer: VLI manufacture String
dec 04 05:22:58 mx kernel: usb 2-1: SerialNumber: 000000123AFF
dec 04 05:22:58 mx kernel: usb-storage 2-1:1.0: USB Mass Storage device detected
dec 04 05:22:58 mx kernel: usb-storage 2-1:1.0: Quirks match for vid 2109 pid 0711: 2000000
dec 04 05:22:58 mx kernel: scsi host3: usb-storage 2-1:1.0
dec 04 05:22:58 mx mtp-probe[31054]: checking bus 2, device 17: "/sys/devices/pci0000:00/0000:00:14.0/usb2/2-1"
dec 04 05:22:58 mx mtp-probe[31054]: bus: 2, device: 17 was not an MTP device
dec 04 05:22:59 mx mtp-probe[31084]: checking bus 2, device 17: "/sys/devices/pci0000:00/0000:00:14.0/usb2/2-1"
dec 04 05:22:59 mx mtp-probe[31084]: bus: 2, device: 17 was not an MTP device
dec 04 05:23:20 mx kernel: usb 2-1: reset SuperSpeed USB device number 17 using xhci_hcd
This cable has connected fine to previous ssd’s.
Maybe the drive just had a typical ssd reactive failure 🤔
(Disk Manager is just a gui mount tool shipped with mx.)
deleted by creator
For future reference…
The output of dmesg, with working drive and usb-sata cable:
[21697.558147] usb 2-2: new SuperSpeed USB device number 18 using xhci_hcd [21697.587491] usb 2-2: New USB device found, idVendor=2109, idProduct=0711, bcdDevice= 1.44 [21697.587509] usb 2-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3 [21697.587518] usb 2-2: Product: VLI Product String [21697.587525] usb 2-2: Manufacturer: VLI manufacture String [21697.587531] usb 2-2: SerialNumber: 000000123AFF [21697.590092] usb-storage 2-2:1.0: USB Mass Storage device detected [21697.590736] usb-storage 2-2:1.0: Quirks match for vid 2109 pid 0711: 2000000 [21697.590984] scsi host3: usb-storage 2-2:1.0 [21699.441247] scsi 3:0:0:0: Direct-Access USB3.0 high speed 2210 PQ: 0 ANSI: 6 [21699.441988] sd 3:0:0:0: Attached scsi generic sg2 type 0 [21699.442809] sd 3:0:0:0: [sdc] 468862124 512-byte logical blocks: (240 GB/224 GiB) [21699.443369] sd 3:0:0:0: [sdc] Write Protect is off [21699.443382] sd 3:0:0:0: [sdc] Mode Sense: 2f 00 00 00 [21699.443975] sd 3:0:0:0: [sdc] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA [21699.447303] sdc: sdc1 sdc2 < sdc5 > [21699.447882] sd 3:0:0:0: [sdc] Attached SCSI disk [21704.928734] EXT4-fs (sdc1): mounted filesystem with ordered data mode. Quota mode: none.